This is a crucial step, and one you shouldn't skip. Some settings such as support density are not included in the table, as they are heavily dependent on the 3D model. The names of the settings might be different depending on which slicer you use (eg. further parameters, instructions or obervations. The source will often contain important additional information that would not fit on the table. You might find its settings for another printer, which should still be helpful. If you are looking for a specific resin, but cannot find it here, try the Master MSLA printer settings spreadsheet. You can search the table for a certain property you are interested in, such as 'red' or 'flexible.' You could also try looking for a resin with a low curing time, or one with multiple upvotes. How to use the spreadsheet (Step-by-step) 1. The spreadsheet is not a substitute for resin validation, but a good starting point for it, allowing you to build on what others have already worked out. The following settings have been crowdsourced from community forums, manufacturers, Maker Trainer users etc. You can always figure this out through some experimentation, but using ones which are already confirmed by other users can save you a lot of time and frustration.įile:Uniz SLASH 2.jpg Uniz SLASH 2 resin settings spreadsheet This gives you a great amount of freedom, but comes with its own challenge of knowing which resins are compatible, and how to print them. The SLASH 2 is an open material 3D printer, meaning it can print with any brand of resin, not just the ones made by Uniz. Below you can find a list of resins which are compatible with the Uniz SLASH 2.

Uniz slash 2